Filter
Top Products
17
From the Base
1. Press INT.COM/PAGE on Base.
2. The INT.COM/PAGE LED on Base
and the INT.COM/LOW BATT LED
on Handset will blink and a tone
will sound at Handset.
To exit Intercom mode at the Base Unit
or Handset, press OFF.
3. To answer the page at the Hand-
set, press INT.COM and speak with
the person at the Base Unit.
NOTE:
1.The Handset will ring a maxi-
mum of 60 seconds.
2.If the Handset is in use, it will
ring only once.
To end the Intercom call at the Base or
Handset, press OFF.
If you receive an Intercom/Page from
the Base Unit while you are on a phone
call on the Handset,
1. Press INT.COM key on Handset,
2. Intercom mode is active after a sig-
nal is heard.
2. Either party can leave the conver-
sation by pressing OFF key.
To disconnect the call, both the Hand-
set and the Base Unit must hang up .
Otherwise the call will still remain con-
nected.
USING THE INTERCOM
You can use your VT 9241 2 line
cordless telephone as a two-way Inter-
com between the Base Unit and the
Handset. This doesn’t tie up your tele-
phone line. You can still receive calls
when using the Intercom.
The Intercom function can be activated
by either the Handset or the Base Unit.
From the Handset
1. Press INT.COM key.
2. The INT.COM/LOW BATT LED will
illuminate and a tone will sound.
3. The Base will ring and the
INT.COM/PAGE LED will light. It will
then automatically enter Intercom
mode.
4. Speak towards the microphone on
the front edge of the Base Unit.
OPERATING INSTRUCTIONS
900
MH
Z
CORDLESS
VT9241
CONF
REDIAL
MUTE
HOLD
MEMORY
INT.COM/PAGE
POWER
CHARGE
SPARE BATT
TONE
0
OPER
HOLD CHAN INT.COM
PGM CONF REDIAL
PAUSE
MEM