Filter
Top Products
32
This equipment complies with Parts 15
and 68 of the Federal Communications
Commission (FCC) rules for the United
States. It also complies with regula-
tions RSS210 and CS-03 of Industry
and Science Canada. Operation is
subject to the following two conditions:
(1) this device may not cause interfer-
ence, and (2) this device must accept
any interference, including interference
that may cause undesired operation of
the device.
The underside of the Base Unit con-
taining engravements of either the FCC
registration number and Ringer
Equivalence Number (REN), or the IC
registration number . You must, upon
request, provide this information to
your local telephone company.
This equipment is compatible with in-
ductively coupled hearing aids.
Should you experience trouble with this
telephone equipment, please contact:
In the United States:
VTECH COMMUNICATIONS
1-800-595-9511.
In Canada:
VTECH ELECTRONICS
1-800-267-7377.
The telephone company may ask you
to disconnect this equipment from the
line network until the problem has been
corrected.
FCC Part 15
Warning: Changes or modifica-
tions to this unit not expressly
approved by the party respon-
sible for compliance's could void
the user’s authority to operate
the equipment.
The equipment has been tested and
found to comply with part 15 of the FCC
rules. These limits are designed to pro-
vide reasonable protection against
harmful interference in a residential in-
stallation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not oc-
cur in a particular installation. If this
equipment does cause harmful inter-
ference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is en-
couraged to try and correct the inter-
ference by one or more of the following
measures:
- Reorient or relocate the receiving
antenna.
- Increase the separation between
the equipment and receiver.
- Connect the equipment into an out-
let or on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experi-
enced radio/TV technician for help.
FCC Part 68
The FCC requires that you connect
your cordless telephone to the nation-
wide telephone network through a
modular telephone jack (USOC RJ11C,
RJ11W or RJ14).
Your telephone company may discon-
tinue your service if your equipment
causes harm to the telephone network.
FCC AND IC REGULATIONS