Filter
Top Products
7
CAUTION: Use only
the AC adapter
shipped with your VT
9241. This is a Class
2 AC adapter, specifi-
cally designed for
use with the VT 9241.
GETTING STARTED
Setting Up Your VT 9241
1. Choose an area near an electrical
outlet and a telephone wall jack.
2. Plug the AC power adapter into an
electrical outlet and the DC connec-
tor to the back of the Base Unit.
NOTE: Connect power to the
Base Unit before placing the
Handset in the cradle.
3. Set the TONE/PULSE switch located
on the underside of the Base Unit. If
you have touch tone service on your
phone line, set the switch to TONE.
If you have rotary service, set the
switch to PULSE.
4. Set the RINGER switches to HIGH,
LOW or OFF on the Base Unit.
5. CHARGE THE HANDSET BATTER-
IES BEFORE USE. The batteries
recharge automatically whenever
the Handset is in the Base Unit
cradle. The batteries must be
charged for 16 hours before using
your phone for the first time.
6. Connect the telephone line cord(s).
If you have two lines which are ser-
viced by one telephone jack (RJ14),
insert one end of the four wire (black
tipped) telephone line cord into the
jack marked L1/L2 at the rear of the
Base Unit. Plug the other end into a
telephone wall jack. If your two tele-
phone lines are each serviced by a
separate telephone jack (RJ11),
insert one end of a telephone line
cord into the jack marked L1/L2 (this
will be your line 1) and a second
telephone cord into the jack marked
L2 (this will be your Line2) at the
rear of the Base Unit. Plug the other
end of the telephone cords into the
appropriate wall jacks. Make sure
the plugs snap securely into place.
7. CHECK FOR A DIAL TONE. After
the batteries are charged, pick up
the Handset and press a LINE key.
The LINE key you pressed should
light up, and you should hear a dial
tone. If not, see IN CASE OF DIFFI-
CULTY.
DIAL MODE
PULSE TONE
TELEPHONE
WALL JACK
AC ELECTRICAL
OUTLET
OR
BASE UNIT RINGER
SWITCHES
9V DC
L1/L2
L2
TEL.LINE DATA PORT
LINE 1 LINE 2
RINGER
HIGH OFF
LOW
HIGH OFF
LOW