Filter
Top Products
www.vtechphones.com
5
Getting started
Table/desk installation
Installation
1. Plug the connector of the AC power adapter
to the jack marked AC 9V at the bottom of
the base unit. Plug the AC power adapter
into a standard electrical outlet (110V AC)
not controlled by a wall switch.
2. Connect the telephone line cord to the jack
marked TEL LINE at the bottom of the base
unit. Plug the other end of the telephone line
cord to a wall jack.
If you subscribe to DSL service
If there is interference during telephone
conversations and/or your caller ID features
are not functioning properly, install a noise
unit and the telephone wall jack. Contact
Wall mounting
1. Connect the AC power cord and the
telephone line cord as described in the
Table/Desk Installation section above.