Filter
Top Products
www.vtechphones.com
11
Basic operation
Telephone operation
Base operation
11. CONTRAST
Press the contrast key, to adjust the screen contrast. Repeated
pressing will cycle from lightest to darkest contrast.
12. PROG/MEM
Your base unit can store 10 frequently dialed phone numbers.
Press the PROG/MEM key to dial the numbers stored in
memory.
13. FIND HANDSET/INT
With the handset in idle, press to page the handset. Press
again, or place handset in the base to cancel the page.
14. FLASH
If you have call waiting service, you will hear a beep if there
is an incoming call while you are on a call. Press FLASH to
put the rst call on hold and take the new call. Press again to
switch back and forth between the calls.
15. CHARGE INDICATOR
Illuminates when the handset is charging in the base.
16. LINE 1/LINE 2
Enter the telephone number,up to 32 digits. Press the desired
LINE key. The number will be dialed. To end your call, press
the same LINE key. You can also press a LINE key rst,
then dial the number. Press the appropriate LINE key to
answer a call.
17. VOL /
During an active call, press the VOL or VOL key to adjust
the base speakerphone volume on the base and the current
level is displayed on the screen.
18. CONF
Press to establish conference call on the base.
19. HOLD
During an active call, press HOLD. The corresponding LINE
key will ash to indicate it is on hold. To return to the call,
press the same LINE key again.
20. REDIAL/PAUSE
Press REDIAL/PAUSE, the last phone number dialed from
the base unit is displayed. Press the desired LINE key to
dial that number.
-OR- Press the desired LINE key rst, listen for a dial
tone. Press REDIAL/PAUSE. The displayed number will
be dialed.
While entering numbers, press and hold to insert a dialing
pause.
21. MUTE/CLEAR
With the speakerphone ON, press MUTE/CLEAR, the base
microphone is now muted. Press MUTE/CLEAR again to
return to the two-way conversation.
In pre-dial and programme mode, press to clear function.
11
12
13
14
15
16
17
18
19
20
21