Filter
Top Products
ADDITIONAL INFORMATION [ 51]www.uniden.com
ADDITIONAL
INFORMATION
Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and
the base unit. Normally, setting the code is not necessary. The first time you charge
your handset, the security code is automatically set.
In the rare situation that you suspect another cordless telephone is using the same
security code, you can change the code.
1) Remove the handset from the base unit. Press and hold the find hs key on the
base.
2) While holding the find hs key, place the handset on the base unit, and leave the
handset on the base for more than 3 seconds. A new random security code is set.
Headset Installation
Your phone may be used with an optional headset, the Uniden HS910.
To use this feature, insert the headset plug into the headset jack.
Your phone is ready for hands-free conversations.
(Headset may be purchased by calling the Uniden Parts Department or
visiting the web site. See Quick Reference Guide on page 1.)
Installing the Beltclip
To attach the beltclip
Insert the beltclip into the holes on each
side of the handset. Press down until it
clicks.
To remove the beltclip
Pull both sides of the beltclip to release
the tabs from the holes.
• To protect you against
misbilled calls which
might result from your
phone being activated
by other equipment,
the cordless phone has
AutoSecure
TM
feature
electronically locks
your phone when the
handset is in the base.
Random Code
TM
digital
security which
automatically selects
one of over 262,000
digital security codes
for the handset and
base.
• If the handset battery
pack is completely
discharged or the
battery pack is
removed, the digital
security code will be
lost. If this happens,
a new security code is
set automatically next
time the battery pack
is charged.
EXAI3248_UP004BH UP01004BA_0.Qx 3/14/3 1:35 PM Page 51