Filter
Top Products
GETTING STARTED [ 9]www.uniden.com
GETTING STARTED
Battery use time (per charge)
From fully charged (15-20 hours charge time)
• Up to seven hours continuous use during talk mode.
• Up to fourteen days when the handset is in the standby mode.
Low battery alert
When the battery pack is very low and needs to be charged, the
phone is programmed to eliminate functions in order to save
power. If the phone is not in use, “
Low Battery” appears on
the LCD and none of the keys will operate.
If the phone is in use, “
Low Battery” flashes and the handset
beeps. Complete your conversation as quickly as possible and
return the handset to the base unit for charging.
Cleaning the charging contacts
To maintain a good charge, it is important to clean the
charging contacts on both the handset and base unit
once a month. Use a dry cloth or pencil eraser to clean.
If the contacts became very dirty, using water only,
dampen a cloth to clean the charging contacts.
Then make sure to go back over the charging contacts
with a dry cloth before returning the handset to the
base to charge.
The last number dialed in the redial memory and the numbers
stored in the memory locations are retained for up to 30 minutes
while you replace the battery pack.
• Even when the battery
pack is not being
used, it will gradually
discharge over a long
period of time. For
optimum performance,
be sure to return the
handset to the base
unit after a telephone
call.
• Talk Mode -
The handset is off the
base and talk/flash
has been pressed
enabling a dial tone.
• Standby Mode -
The handset is not in
use, off the base, and
talk/flash has not
been pressed. A dial
tone is not present.
EXAI3248_UP004BH UP01004BA_0.Qx 3/14/3 1:34 PM Page 9