Filter
Top Products
GETTING STARTED [ 11]www.uniden.com
GETTING STARTED
5) Once the handset battery pack is fully charged,
connect the telephone line cord to the TEL LINE
jack and a telephone outlet once the handset is
fully charged.
If your telephone outlet isn't
modular, contact your telephone
company for assistance.
Modular
Mounting the Base Unit on a Wall
Setting the handset retainer clip for wall mounting
1) On the base unit, pull the handset retainer clip out of the
slot and rotate it clockwise 180 degrees.
2) Flip the retainer clip from front to back. Slide it back into
the slot so that the lip of the retainer is up and the
▼ is
down. The retainer holds the handset in place.
Standard wall plate mounting
This phone can be mounted on any standard wall plate.
1) Snap the wall mount adapter into the notches on the base
bottom.
2) Plug the AC adapter to the DC IN 9V jack.
3) Route the AC adapter cord through the molded wiring channel
as shown.
4) Plug the AC adapter into a standard 120V AC wall outlet.
5) Plug the telephone line cord into the TEL LINE jack. Route
the cord through the molded wiring channel as shown.
DO NOT use an AC
outlet controlled by
a wall switch.
Flip the hook tab
over so the tab
holds the handset.
EXAI3248_UP004BH UP01004BA_0.Qx 3/14/3 1:34 PM Page 11