Filter
Top Products
[13] GETTING STARTED
www.uniden.com
When to Re-register Handsets
1) You’ll need to re-register the second handset (follow steps on page 12) each time the digital
security code is changed. Refer to page 51 for details regarding the Digital Security Code.
2) When there is a power failure for more than one hour:
If power failure occurs (e.g. due to electrical storm or if the unit is unplugged during a
move), both handsets will need to be re-registered. To re-register, follow the same
registration process on page 12.
3) If the second handset’s battery becomes very low, the handset must be recharged for 15-
20 hours and re-registered to the main base.
Call Transfer Feature
Your cordless phone allows you to transfer outside calls from handset to handset; only one
handset at a time can talk with an outside caller. The second handset cannot go off hook to
listen to conversations or make an outgoing call while the other handset is in use.
To transfer a call
1) During a call, press the delete/transfer key. The call will
automatically be placed on hold and the transfer tone sounds.
2) When the other handset receives the call, the transfer tone
stops. To cancel the transfer and return to the caller, press the
delete/transfer or talk/flash key on the handset.
To receive a transfer call
Pick up the handset from the cradle (when AutoTalk is set to on),
or pick up the handset and press the talk/flash key to answer
the transferred call. Additionally, you can answer the transferred
call by pressing any number key, (when AutoTalk is set to on).
•Make sure to return the
handsets to the cradles
after each phone call.
•If you transfer the call
and it is not picked up
after 5 minutes, the
call will be
disconnected.
note
GETTING STARTED
UP038.book 13 ページ ２００４年１月２６日 月曜日 午前１０時１７分