Filter
Top Products
THE INTEGRATED ANSWERING DEVICE[ 44 ] www.uniden.com
Selecting the Message Record Time
You have three record time options. The options "1 minute" or "4 minutes" set the
duration for recording the incoming messages. "Announce only" answers the call
with the preset greeting or your personal greeting but prevents the caller from
leaving a message.
1) Press MENU/CLOCK four times in standby mode.
You hear “Record time” and the current recording time ([ ] 1 minute, [ ] 4
minutes, [ ] Announce only, No recording), and it is displayed on the base.
Then you hear the guidance for setting the record time.
2) Press volume/SELECT/ or volume/SELECT/ until the desired time appears.
3) Press SET to select the new recording time. You will hear a confirmation tone,
then the announcement “Record time” followed by the new recording time is
announced. After a few seconds, the system announces “To set message alert,
press menu again”.
▼Announce only feature
The announce only feature plays a prerecorded outgoing message “Hello, no one is
available to take your call. Please call again.”, and it will not allow the caller to
leave a message. To set “Announce only”, follow the steps above.
To scroll between the prerecorded message or your own personal greeting, press
greeting when the outgoing message is played. If you want to use your own greeting
or want to omit the prompt “to leave a message from your greeting”, refer to
“Recording a personal outgoing message (Greeting)” on page 46.
After setting the
Announce only feature,
you may want to change
your outgoing message
not to prompt the caller
to leave a message.
However, the prerecorded
message changes
automatically.
EXAI5180 9/17/03 10:21 AM Page 44