Filter
Top Products
GETTING STARTED
GETTING STARTED [ 11]www.uniden.com
•Even when the
battery pack is not
being used, it will
gradually discharge
over a long period
of time. For optimum
performance, be sure
to return the handset
to the base unit after
a telephone call.
• Talk Mode -
The handset is off the
base and talk/flash
has been pressed,
enabling a dial tone.
• Standby Mode -
The handset is not in
use. The handset may
be in or off the base,
but talk/flash has
not been pressed.
Cleaning the battery charging contacts
To maintain a good charge, it is important to clean the
charging contacts on both the handset and base unit once
a month. Using water only, dampen a cloth to clean the
charging contacts. Then make sure to go back over the
charging contacts with a dry cloth before returning the
handset to the base to charge.
The last number dialed in the redial memory, the names and the numbers stored in the
memory locations and CID list are retained for up to 30 minutes while you replace the
battery pack.
Low battery alert
When the battery pack is very low and needs to be charged,
the phone is programmed to eliminate functions in order to
save power. If the phone is not in use,
Low Battery appears
on the LCD and none of the keys will operate.
If the phone is in use,
Low Battery flashes and the handset
beeps. Complete your conversation as quickly as possible and
return the handset to the base unit for charging.
Do not use paint thinner, benzene, alcohol, or other chemical products. Doing so
may discolor the surface of the telephone and damage the finish.
EXAI5180 9/17/03 10:19 AM Page 11