Filter
Top Products
5
1. Snap the desktop/wall mount
adapter into the top of the base
as shown.
2. Plug the AC adapter cord into the 10
VDC input jack on the back of the base.
3. Wrap the AC adapter cord around the
strain relief notch.
4. Plug the AC adapter into a standard 120V AC wall outlet.
5. Charge the battery (See CHARGING THE BATTERY PACK,
page 11).
6. Plug one end of the long telephone cord into the
TEL LINE
jack on
the back of the base.
7. Plug the other end of the cord into the
telephone jack on the wall.
8. Set the base on a desk or tabletop with
the keypad facing either facing up or
down. Place the handset into
the base. Raise the antenna to a
vertical position.
DESK/TABLETOP INSTALLATION
Before using your phone,
fully charge the Nickel-
Cadmium battery pack
for 15-20 hours.
Place the power cord so
that it does not create a
trip hazard or where it
could become chafed
and create a fire or
electrical hazard.
Use only the Uniden AC
adapter supplied with
this phone. DO NOT use
an outlet controlled by a
wall switch.
exs9800 User's Manual.qxd 3/3/99 4:30 PM Page 5