Uniden EXI2926 Cordless Telephone User Manual


 
ADDITIONAL INFORMATION [ 31 ]
ADDITIONAL INFORMATION
Troubleshooting
If your phone is not performing to your expectations, please try these simple steps first.
SSyymmppttoomm
The status LED won´t light
when the handset is
placed in the base unit.
SSuuggggeessttiioonn
Make sure the AC adapter is plugged into the base unit and wall outlet.
Make sure the handset is properly seated in the base unit.
Make sure the charging contacts on the handset and base unit are clean.
Press chan during a call to help eliminate background noise.
Make sure that the base unit antenna is in a vertical position.
Move the handset and/or base unit to a different location away from metal objects or appliances and
try again.
Make sure that you are not too far from the base.
Check both ends of the base unit telephone line cord.
Make sure the AC adapter is plugged into the base unit and wall outlet.
Disconnect the AC adapter for a few minutes, then reconnect it.
Reset the digital security code (See page 29).
Make sure line 1 or line 2 is pressed.
The battery pack may be weak. Charge the battery on the base unit for more than 15 hours.
The handset may be too far away from the base unit.
Place the base unit away from appliances or metal objects.
Reset the digital security code (See page 29).
Keep the handset away from microwave ovens, computers, remote control toys, wireless
microphones, alarm systems, intercoms, room monitors, fluorescent lights, and electrical appliances.
Move to another location or turn off the source of interference.
The handset was picked up before the second ring.
The call was placed through a switch board.
Call your local telephone company to verify your Caller ID service is current.
Make sure that the CIDCW option is set to "On".
Charge the handset.
The audio sounds weak
and/or scratchy.
Can´t make or receive calls.
The handset doesn´t ring
or receive a page.
The Caller ID/CIDCW does
not display.
Severe noise interference.
EXI2926 ENG Resize 9/4/01 2:03 PM Page 31