Filter
Top Products
ADDITIONAL INFORMATION [ 29 ]
ADDITIONAL INFORMATION
Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and the base unit. Normally,
setting the code is not necessary.
The first time you charge your handset, the security code is automatically set. (See page 4.) In the rare situation
that you suspect another cordless telephone is using the same security code, you can change the code.
1) Remove the handset from the base unit.
2) Press and hold intercom on the base.
3) The handset is emitting the paging sound place the handset on the base unit. While holding intercom for at
least 3 seconds, the paging sound stops. Leave the handset on the base for more than 3 seconds or until the
status LED stops flashing. A random, new security code is set.
Installing the Beltclip
TToo aattttaacchh tthhee bbeellttcclliipp
Insert the beltclip into
the holes on each side
of the handset. Press
down until it clicks.
TToo rreemmoovvee tthhee bbeellttcclliipp
Pull both sides of the
beltclip to release the
tabs from the holes.
Headset Installation
Your phone may be used with an optional
headset, the Uniden HS910. To use this feature,
insert headset plug into the headset jack. Your
phone is ready for hands-free conversations.
(Headset may be purchased by calling the Uniden
Parts Department or visiting the web site. See
Page 5.)
If you are using an optional headset,
you must still use the handset
keypad for phone operations.
note
•If the handset
battery pack is
completely
discharged or the
battery pack is
removed, the
digital security
code will be lost.
If this happens, a
new security code
is set automatically
next time the
battery pack is
charged.
•Use only Uniden
HS910 headset
specifically
designed for
Uniden phones.
•If the beltclip is
attached, you can
only charge the
handset in the face
down position.
EXI2926 ENG Resize 9/4/01 2:03 PM Page 29