Filter
Top Products
GETTING STARTED[ 10 ]
1
2
DO NOT use an
outlet controlled by
a wall switch.
!
note
If you have wall
mounted the base,
you must remove
the beltclip to hang
the handset with
the display facing
forward.
DDiirreecctt wwaallll mmoouunnttiinngg
If you don´t have a standard wall plate, you can mount your phone directly to the wall. Before doing this,
consider the following:
• Avoid electrical cables, pipes, or other items behind the mounting location, that could cause a hazard
when inserting screws into the wall.
• Try to mount your phone within 6-10 feet of a working phone jack to avoid excessive cord lengths.
• Make sure the wall material is capable of supporting the weight of the base and handset.
• Use #10 screws (minimum length of 1-3/8 inches) with anchoring devices suitable for the wall material
where the base unit will be placed.
SSttaannddaarrdd wwaallll ppllaattee mmoouunnttiinngg
This phone can be mounted on any standard telephone wall plate.
1) Snap the wall mount adapter into the notches on the base.
2) Plug the AC adapter to the DC IN 9V jack.
3) Wrap the AC adapter cord inside the molded wiring channel as shown.
4) Plug the AC adapter into a standard 120V AC wall outlet.
5) Place the handset on the base unit and charge for 15-20 hours.
6) Plug the telephone line cord into the TEL LINE jack.
Wrap the cord inside the molded wiring channel as shown.
7) Plug the telephone line cord into the telephone outlet.
8) Raise the antenna to a vertical position.
9) Align the mounting slots on the base with the mounting posts on the wall
then push in and down until the phone is firmly seated.
EXI2926 ENG Resize 9/4/01 2:02 PM Page 10