Filter
Top Products
BASICS[ 16 ]
Flash and Call Waiting
If you have "Call Waiting" service and a call waiting tone sounds while you are on a call,
press delete/flash to accept the waiting call. There is a short pause, then you will hear the
new caller. To return to the original caller, press delete/flash again.
note
You must subscribe through your local telephone company to receive Call Waiting Service.
Answering a Call from the Base
1) The base rings. The corresponding line 1 LED on the base flashes.
2) Press the line 1 and speak.
3) When you finish the call, press line 1 to hang up.
Answering a Call from the Handset
1) The handset rings and the following screen appears:
2) Press the line 1 to answer your call.
3) When you finish the call, press line 1 on the handset, or return the handset to the base.
(Call)
Line 1
Making a Call from the Base
1) Press line 1.
2) Dial the number on the keypad, or use one of the memory features.
(See "Making Calls with Memory Dialing", page 22.)
3) When you finish the call, press line 1 to hang up.
note
The flash feature
does not function
when line 1 and
line 2 are on a
conference call.
(See 3-way
conferencing and 4-
way conferencing,
pages 18 and 19).
If you set the
handset in AutoTalk
on, and the handset
is on the base, just
pick up the handset
and speak. Each
line setting is
independent for
this feature.
note
EXI2926 ENG Resize 9/4/01 2:03 PM Page 16