Filter
Top Products
▼ Other Functions
You can access other functions such as checking recorded messages, playing or
deleting messages, etc. remotely using a touch-tone phone.
1. Call your telephone number.
2. While the outgoing message is playing, press # followed by your PIN code.
(For instructions to set your PIN code see page 28).
3. The answering system announces the time and day followed by the number of
messages in memory. Message playback automatically begins.
4. You may listen to your messages, or you may select a command from the
following chart:
5. After all of your messages have played, intermittent beeps indicate that your
system is in Command Waiting mode. At this time, you may enter another
command from the chart above.
6. When you are finished, hang up to exit the system. The answering system
automatically returns to Standby.
FUNCTION PRESS
Repeat # then 1
Play # then 2
Skip # then 3
Delete # then 4
Stop # then 5
Answer On # then 6
Memo Record/Stop # then 7
Ogm Record/Stop # then 8
Answer Off # then 9
Monitor # then
*
You must enter a command
within 15 seconds of
entering Command Waiting
mode or the answering
system automatically hangs
up and returns to Standby.
The system will only
playback messages for four
minutes and then it returns
to Command Waiting mode.
To continue playing your
messages, press # then 2
again within 15 seconds.
33
ANSWERING DEVICE USE