Filter
Top Products
9
1. Snap the desktop/wall mount
adaptor into the top of the base
as shown.
2. Plug the AC adaptor cord into the 10V
DC input jack on the back of the base.
3. Wrap the AC adaptor cord around the strain relief notch.
4. Plug the AC adaptor into a standard 240V AC wall outlet.
5. Charge the battery (See CHARGING THE BATTERY PACK,
page 15).
6. Plug one end of the telephone cord into the
TEL LINE jack on the back
of the base.
7. Plug the other end of the cord into the
telephone jack on the wall.
8. Set the base on a desk or tabletop with the
keypad facing up or down then place the
handset into the base. Raise the antenna to
a vertical position.
AC
Adapter
Line in
From
Telephone
Jack
RESET
TEL LINE
PULSE-TONE
OFF-ON
DC IN 10V
RINGER
DESK/TABLETOP INSTALLATION
Before connecting your
phone line, fully charge the
Nickel- Cadmium battery
pack for 15-20 hours.
Place the power cord so
that it does not create a trip
hazard or where it could
become chafed and create a
fire or electrical hazard.
Use only the Uniden AC
adaptor supplied with this
phone plugged to
uninterrupted power supply.
INSTALLATION & ADJUSTING