Filter
Top Products
5
If you have a DRX332 handset with a MULTIRANGE
™
charger,
be sure to use the correct AC adapter for the charger. Refer to
the table on page 2 for a list of adapters/voltage requirements.
For MULTIRANGE chargers, route the cord as shown:
Plug the other end of each adapter into a
standard 120V AC power outlet.
Place one handset in the base and the
other(s) in the charger(s) with the
display(s) facing forward. The handset
display should light up; if it doesn’t, reseat
the handset or try plugging the AC adapter into a different outlet.
Charge all handsets completely (about 15 hours) before using
them.
Connect the telephone cord
Connect the
TEL LinE
jack to a standard telephone wall jack.
Test the connecon
Pick up the handset from the cradle and press
TaLk/fLash
. You
should hear a dial tone, and the display should say Talk.
If you don't hear a dial tone or the display says Check Tel Line,
try checking the connection between the base and the phone
jack.
Make a quick test call. (Press
End
to hang up.)
If the tone doesn’t stop when you dial, try changing to pulse
dialing mode (see page 31).
If there's a lot of noise or static on the call, see page 29 for tips
on avoiding interference.
Test any accessory handsets the same way. If you can’t get a dial
tone or the handset display says Unavailable, try resetting the
handset (see page 31).
Seng Up MULTIRANGE Chargers
If the model number ends in an R, at least one of the chargers
included with your phone is a MULTIRANGE charger.
6.
7.
1.
2.
3.