Filter
Top Products
33
On the bottom of the MULTIRANGE charger,
press and hold the registration button until
the
Link
light starts to blink (about 2
seconds). Release the button and wait for the
Link
light to turn on and steady (this can
take about 90 seconds).
If the
Link
light doesn't turn on or keeps
blinking, disconnect the charger's AC adapter. Wait about 20
seconds, then try these steps again.
Some important things to remember:
Only register one charger at a time. If more than one charger is in
registration mode at the same time, they can interfere with each
other.
If you want to use the MULTIRANGE charger with a different
base, just register the charger to the new base. The charger
automatically erases the link to the old base when it registers to
the new one.
Only register chargers to one base at a time. If more than one base
is in registration mode at the same time, you can't control which
base the charger registers to.
AC Adapter and Baery Informaon
Use only the supplied AC adapters. Be sure to use the proper
adapter for the base and any chargers.
Do not place the power cord where it creates a trip hazard or
where it could become chafed and create a fire or electrical hazard.
Do not place the unit in direct sunlight or subject it to high
temperatures.
Fully charged, the battery should provide about 10 hours of talk
time and about 7 days of standby time. For best results, return the
handset to the cradle after each call to keep it fully charged.
When the battery gets too low, the handset shows a low battery
alert. If you hear a strange beep during a call, check the display: if
you see the low battery alert, finish your conversation as quickly
as possible and return the handset to the cradle. If the handset is
in standby, none of the keys will operate.
2.