Filter
Top Products
26
handset at a time can screen calls. If another handset is screening the
call, the handset beeps and returns to standby.
To... From the base... From a handset...
hear the caller
leaving a message
Just listen to the
caller over the
speaker.
Press
MEssagEs
.
answer the call Not available. Press
TaLk/fLash
.
mute the call screen
without answering
Press
PLaY/sToP
.
Press
End
or return the
handset to the cradle.
If you mute the call screen, the system continues
taking the message: it just stops playing through
the speaker.
Using the System While You’re Away from Home
You can also use your answering system from any touch-tone phone.
Before you can use this feature, you must program a security code.
Programming a security code
With the phone in standby, open the menu from any handset.
Select Ans. Setup, then select Security Code.
Use the number keypad to enter a two-digit security code (01 to
99). Press
MEnu/sELECT
when you’re finished.
Remember to make a note of your new security code!
Dialing in to your system
Call your telephone number and wait for the system to answer.
If you have the Ring Time set to Toll Saver, the system
answers after 2 rings if you have new messages and 4 rings if
you don’t. You can hang up during the third or fourth ring.
If your answering system is off, it will answer after about ten
rings and sound a series of beeps instead of your greeting.
1.
2.
3.
1.