Filter
Top Products
36
Plug the DSL filter into the telephone wall jack and plug your phone’s base
into the filter. Make a test call to make sure the noise is gone.
Do you use a T-Coil hearing aid?
If you have a hearing aid equipped with a telecoil (T-coil) feature, the
interaction between the hearing aid and digital cordless phones can
cause noise in the handset. If you have a T-coil hearing aid and you have
problems with noise on the line, try turning on
T-coil
mode. Open the
menu. Select
Handset Setup,
then select
T-coil
.
Using T-coil mode can shorten the handset’s talk time; make sure to
watch the battery status and keep the battery charged.
Liquid damage
Moisture and liquid can damage your cordless phone. If the exterior
housing of the handset or base is exposed to moisture or liquid, wipe off
the liquid, and use as normal. If moisture or liquid is inside the plastic
housing (i.e. liquid can be heard in the phone or liquid has entered the
handset battery compartment or vent openings on the base), follow these
steps:
Handset Base
Remove the battery cover and
disconnect the battery.
Let dry for at least 3 days with the
battery disconnected and the cover off
for ventilation.
After the handset dries, reconnect the
battery and replace the cover. Recharge
the battery fully before using.
-
-
-
Disconnect the AC
adapter to cut off the
power.
Disconnect the
telephone cord.
Let dry for at least
3 days before
reconnecting.
-
-
-
CAUTION! DO NOT use a microwave oven to speed up the
drying process. This will cause permanent damage to the
handset, base, and the microwave oven.
Changing from Tone to Pulse Dialing
Your phone communicates with the land line telephone network two
ways: tone dialing or pulse dialing. Most telephone companies use tone
-
-