Filter
Top Products
17
The Ans. Setup menu
This menu controls the options and settings for your answering system
(see page 27).
The Global Setup menu
The settings on this menu affect all handsets and the base. Before
changing these settings, make sure the phone is in standby and all
handsets are within range of the base. (Only one handset at a time can
change these settings.)
Setting What it does
Dial Mode
Change the way your phone communicates with
the land line telephone network (see page 36).
Set Line Mode
Do not change this setting unless instructed to by
customer service.
VMWI Reset
Reset the message waiting indicator if it gets out of
sync with your voice mail service (see page 26).
How to enter text on your phone
Use the 12-key dial pad when you want to enter text into your phone (a
name in the phonebook, the handset banner, etc.).
The phone defaults to a capital letter for the first letter and any letter
after a space; otherwise, it uses small letters.
To switch to all capital letters, press
*
. The phone defaults to all
capital letters first (e. g. ABCabc2) until you enter a blank space or
press
*
again. (Any time you want to change case, just press
*
.)
If two letters in a row use the same number key, enter the first letter
and wait a few seconds (or press
RighT
); the cursor will move to the
next space. Enter the next letter.
Press
#
to enter a blank space.
To change a letter, move the cursor to that letter and press
cLEaR
to
erase the letter; enter the new one.
To erase the entire entry, press and hold
cLEaR
.
Press
0
to cycle through all available symbols and punctuation.