Filter
Top Products
[34] BASICS
www.uniden.com
Mute Microphone
With the handset
You can temporarily turn Off the microphone so that the person you are talking with cannot hear you.
1)Press menu/del during talk mode (while phone is in use).
2)Press ring/vol/∧ or ring/vol/ ∨ to move the pointer to
Mute
and then select/.
Mute On
and appear in the display. To cancel muting, repeat above step again when Mute
is set to on,
Mute Off
appears.
With the base
While using the base speakerphone, press mute on the base to turn Off the microphone.
Press mute again or press (speaker) to cancel muting.
Tone Dialing Switch-over
Some telephone companies use equipment that requires pulse dialing (sometimes referred to
as rotary dialing). If you need to enter tone dialing digits, you can switch-over to tone
dialing during the call. This feature is useful when you need tone dialing to use automated
systems, for example, entering your bank account number after you have called your bank.
Initially make your call with the pulse dialing mode. Once your
call connects, press
*
/tone/←. Enter the desired number.
These digits will be sent as tone dialing. Once the call ends,
the tone mode is canceled and pulse dialing mode resumes.
Traveling Out-of-Range
During a call, as you begin to move your handset too far from your base unit, noise may
increase. If you pass the range limits of the base unit, you will hear a beep and see
Out of
Range
on the display, and then the handset returns to standby mode. You may return back to
the call if you move your handset within the range limits of the base and press talk /flash or
speaker within 30 seconds.
ߦ
•The tone feature only
applies when the dial
mode is set to pulse.
•This special number
can be stored in a
memory location. This
is referred to as Chain
Dialing (see page 44).
note
BASICS