Filter
Top Products
[ 42 ] THE INTEGRATED ANSWERING DEVICE
Remote access away from home
You can operate your answering system from a remote location using any touch-tone telephone.
Use this function to check for recorded messages, to play or delete messages, even to record a new
outgoing message, and to monitor sounds in the room.
1 Call your telephone number.
2 While the greeting message is played, press
#
and your PIN code.
If the answering system is off, let it ring 10 times until the greeting message is played. Then,
press
#
and your PIN code.
3 The answering system announces the time and day stamp and the number of messages stored
in memory. Then the message playback automatically begins.
4 You may continue to listen to your message, or you may select a command from the
following chart.
Command Function
#
then 1 Repeat a message
#
then 2 Playing your messages
#
then 3 Skipping a message
#
then 4 Deleting a message
#
then 5 Stop message playback
#
then 6 Answering system on
#
then 7 Voice memo record/stop (up to 4 minutes recording time)
#
then 8 Greeting message record/stop
#
then 9 Answer system off
#
then
*
Room monitor
5 After all of your messages have played, or the playback time exceeds 4 minutes, you will hear
that the intermittent beeps indicating that the system is in the command waiting mode. You
may enter another command at this time from the chart above.
6 When you finish, hang up to exit the system.
The answering system automatically returns to standby.
• During the remote
operation,
rC
displays on the
base.
• You must enter a
command within
15 seconds of
entering command
waiting mode or
the answering
system
automatically
hangs up and
returns to standby.
• The system will
only playback
messages for four
minutes and then
it returns to
command waiting
mode. To continue
playing your
message, press
#
then 2 again
within 15 seconds.
TRU248_2.4GHz_OM 7/26/00 1:12 PM Page 42