Filter
Top Products
[ 38 ] THE INTEGRATED ANSWERING DEVICE
Selecting the message record time
You can set your answering system to record messages up to one or four minutes long.
One minute option:
move the
REC TIME switch to 1.
Four minutes option:
move the
REC TIME switch to 4.
▼ Announce only feature:
The announce only feature plays an outgoing message, but it will not allow the caller to leave a
message. Move the
REC TIME switch to the ANN position.
The message counter LED displays “
A
” when system is on standby.
Prerecorded outgoing message for Announce only feature is:
“Hello, no one is available to take your call.” (twice)
Selecting a PIN code
To play your messages from a remote location, you will need to enter a two-digit Personal
Identification Number (PIN) code (00-99). To select a PIN, perform the following steps.
1 On the base, press and hold until a beep sounds and the LED displays
00
.
2 To set the first number, press or repeatedly to scroll from 0 to 9. When
the desired number appears in the display, press .
3 To set the second number, press or to scroll from 0 to 9. When the
desired number appears in the display, press . Then the entered PIN code is announced.
repeat
skip
repeat
skip
Holding or
to scroll
through numbers on
the display.
repeat
skip
TRU248_2.4GHz_OM 7/26/00 1:12 PM Page 38