Toshiba DKT2510-FSD Telephone User Manual


 
110
Strata CT Digital Telephone User Guide November 2001
Volume Controls The Single Digital Telephone Grand Tour
Volume Controls
Your telephone has
Vol
/
Vol
buttons to increase and decrease ring tone and handset volume
levels.
You must hold down either button for at least 1/8 second for any volume change to occur. If you
continually hold down either button, the volume continually changes about every half second until the
level limit is reached. You hear ring tone as long as you press a Volume button when your telephone is
idle.
The method for changing feature volume varies. Some features can be adjusted using only the
Vol
/
Vol
and others require additional buttons (see Table 13).
On-hook/Off-hook
Some procedures in this user guide instruct you to perform a step while on-hook or off-hook.
These terms refer to the position of the handset. Off-hook indicates that the handset should be lifted
off of the telephone cradle. On-hook indicates that the handset should remain in the cradle and
should not be lifted.
Internal Call (while station ringing)
The Line LED flashes 10 pulses/second1 second
OFF
Red flashing or ringing
Conference 10 pulses/second steady
Table 13 Using only Vol /Vol
Feature Phone Status Comments
Ring Tone Volume On-hook, Idle Use to adjust the volume of your incoming calls.
Handset Receiver Off-hook
After a call is terminated and the handset is on-hook, the volume level
returns to the original level for the next call. This original level can be
adjusted to higher/lower in system programming.
Table 12 LED Indicators (continued)
Use
Your Station Other Station
Interval Rates