Filter
Top Products
User’s manual
4-6
OPERATING BASICS
NOTE: When the drawer is fully opened, the edge of the computer will
extend slightly over the CD/DVD tray. Therefore, you will need to turn
the CD/DVD at an angle when you place it in the tray. After seating the
CD/DVD, however, make sure it lies flat, as shown in figure 4-5.
CAUTIONS: 1. Do not touch the laser lens. Doing so could cause
misalignment.
2. Do not keep foreign matter from entering the drive.
Check the back edge of the tray to make sure it carries
no debris before closing the drive.
4. Press gently at the center of the CD/DVD until you feel it click into place. The
CD/DVD should lie below the top of the spindle, flush with the spindle base.
5. Push the center of the drawer to closd it. Press gently until it locks into place.
CAUTION: If the CD/DVD is not seated properly when the drawer is
closed, the CD/DVD might be damaged. Also, the drawer might not open
fully when you press the eject button.
Figure 4-6 Closing the DVD-ROM drawer