Filter
Top Products
8
Deskmaster
3.2 Place
For the placement of your phone, please ensure:
• Do not place the phone in an area where it may come into contact with water and chemicals.
• Plastic support pads of the phone:
The equipment has been manufactured for usage in normal environments. Chemical influences
from the area, in which you place the phone (chemicals used for the maintenance of furniture)
may have an impact on the plastic pads.
This may then result in unwanted damage to the furniture surface. In the environment of new or
refreshed furniture, we therefore suggest you to place the phone on a nonskid mat (cloth etc.).
• Hands free speaking:
The hands free facility enables communication with the handset on hook. Other persons in the
room may then participate in the phone call.
In order to achieve best hands free quality, please mind the following:
The environment of the phone should not be covered by subjects such as piles of paper, coffee
pots etc. It is suggested to ensure a free area of at least 15 cm at the front right part of the
phone.
3.3 Security Notes
The ISDN Deskmaster has been manufactured in accordance with EN60950 :1992. The adaptor supplied
with the analog port version is also in accordance with EN60950.
The plug may only be operated at 230V mains supply. Please verify that the isolation of the adaptor is
neither damaged nor defective.
Attention: During operation, dangerous voltages may be generated in the phone. Do not try to open the phone. The
phone contains no parts, which could be repaired by the customer. The supplier does not assume any liability for usages
outside the warranty and safety regulations.
3.4 Cleaning
The phone can be cleaned without any problem. Please ensure the following:
•Wipe the phone with a damp cloth or use antistatic material.
• Never use a dry cloth for cleaning. (Static electricity may lead to electronic defects.)
Please take care that no liquid gets inside the equipment (switches and contacts may be damaged).
3.5 Disconnecting the Line Cord(s) from the Phone
•Press the lock towards the plug.
• Simultaneously pull the plug at the cord out of the telephone.
Note : The same procedure is also applicable for the analog port cable.
HL_DM5201_GB.qxd 16-04-2003 13:24 Page 8