Filter
Top Products
SX5 SETUP
RUIM Card Installation (RUIM Model Only)
Consult your service provider to determine if your unit is a RUIM model. If so, your SX5 will only
be able to make emergency calls until you install a RUIM card. It will not receive calls or allow
non-emergency outgoing calls. For an explanation of how to configure your RUIM once your SX5
is set up, see RUIM Usage (page 6).
1. Remove the power supply if it has already been connected. The power supply must be
removed whenever a RUIM Card is removed or installed.
2. Remove the RUIM compartment cover. - see Figure 1.
3. Open the RUIM compartment holder.
4. Line up the RUIM card with the arrow on the RUIM card holder - see Figure 2.
5. Gently insert the RUIM card in the slot of the RUIM card holder.
6. Close the RUIM card holder.
NOTE: Do not force the RUIM card holder shut. Make sure the RUIM card is aligned properly
with the directional arrow on the holder.
7. Reattach the RUIM compartment cover, closing it with the separate cover screw provided.
Emergency Batteries
Install Batteries
1. Remove the battery access door screw located on the bottom of the unit - see Figure 3.
2. Open the battery compartment by lifting the access tab in the battery compartment’s center -
2. see Figure 3. A new unit may require some extra force to open the compartment.
3. Install 4 “AA” alkaline batteries (not supplied). and re-secure the door with screw.
RUIM Compartment Cover
RUIM Card
Holder
RUIM Card
Figure 1 - RUIM compartment cover.
Cover Screw
Figure 3 –
Battery access door.
Battery Access
Door Tab And
Screw
Battery Access
Door
4 AA Batteries
Figure 4 - Battery installation.
Figure 2 - RUIM card installation.
WARNING!
Only “AA” alkaline batteries are to be used with the Phonecell
®
SX5.
Use of any other batteries may result in fire and/or other damage to the unit.
!
Phonecell
®
SX5 CDMA 1 User Manual