Filter
Top Products
SENDING/RECEIVING 1X DATA
Check with your service provider to see if your account supports 1X data transfer.
Choose the Port the SX5 Will Use for 1X Data
1. Start by pressing MENU.
2. Select 6: Data Settings.
3. Select 1: Data Port Map.
4. Select RS-232 or USB and Press STO to save.
Set the SX5’s Baud Rate for 1X Data
1. Start by pressing MENU.
2. Select 6: Data Settings.
3. Select 4: Baud Rate.
4. Select 115200 and Press STO to save. This is the communication speed between the
computer and SX5; data transfer rates will be much slower.
Set Your Computer’s Port and Modem Speeds for 1X Data
To send or receive circuit switched data, you need to set the port and modem speeds your
computer uses for the SX5 to 115200 bps. See Windows XP/2000 Setup (pages 24 & 26) or
Windows 98 Setup (page 28) for details. This is the communication speed between the
computer and SX5; data transfer rates will be much slower.
To Send or Receive 1X Data
Follow your service provider’s directions for sending and receiving 1X data. Whenever your
software asks you what modem to use, select the Standard 19200 Modem.
For Windows XP and Windows 2000, you can start by opening Control Panel > Network and
Dial Up Connections, then double-clicking on “Make New Connection” to start the Network
Connection Wizard.
For Windows 98, you can start by running “Dial-Up Networking” and double-clicking on “Make
New Connection”.
Note: Taking the SX5 off hook during a data session will end the session.
Phonecell
®
SX5 CDMA 32 Technical Manual