Filter
Top Products
Phonecell
®
SX5 CDMA 5 User Manual
3. Snap the wedge tabs on the thick end of
the wedge into the top tab slots - see
Figure 14. The wedge will fit snugly, so it
may be necessary to press the thick end
of the wedge towards the bottom tab slots
(if the wedge tabs at the thin end have
been inserted) in order to snap it into the
top tab slots.
4. Mark two hole locations 83 mm (3-1/4
inches) vertically apart and drill two holes
into the wall.
5. Install the screws (not supplied) into the
wall, leaving a gap of approximately 3 mm
(1/8 inches) between the screw head and
the wall.
6. Align the mounting holes with the screws
and mount the SX5 onto the screws - see Figures 15 and 16.
Connect the SX5 to AC Power
1 Connect the barrel connector of the power supply to the AC power input on the rear panel of
the SX5 - see Figure 17.
2. Plug the AC power cord into the power supply.
3. Turn the AC/Battery switch to the AC position.
4. Plug the AC power cord into the wall socket. The SX5 will power up automatically.
5. Check the cellular signal strength and move the unit until the best signal possible is
achieved - see the Service Indication section of this manual.
AC Power Cord
Wall Socket
Power Supply
AC Power
Input
Barrel
Connector
Figure 16 – Mount the SX5 onto the screws.
83 mm (3-1/4 inches)
Figure 15 – SX5 mounting hooks.
Mounting
Holes
Attach thick end of
wedge at bottom
of the SX5.
Figure 14 - Wedge attached for wall-mounting.
AC/Battery
Switch
Figure 17 –
SX5 AC power connection.