Filter
Top Products
DETAILED CONFIGURATION & REFERENCE | 53
combined mix of all callers’ audio, and require only one mix-minus feed from the console.
All callers hear the one console mix-minus feed and each other.
e following table summarizes the effect of each mix-minus mode together with each Show
mode:
Mix-Minus Mode
Separate
Mix-Minus Mode
1 in/Multiple out
Mix-Minus Mode
1 in/1 out
Show Mode
One-show
2 in, 2 out, 1 POH
Use analog, AES, or LW.
For AES, POH may be
analog or AES.
1 in, 2 out, 1 POH
Use analog, AES, or LW.
For AES, POH may be
analog or AES.
1 in, 1 out, 1 POH
Use analog, AES, or LW.
For AES, POH may be
analog or AES.
Show Mode
One-show, 4-column
4 in, 4 out, 1 POH
Use AES in 4-channel
mode or LW to access all
the inputs and outputs.
For AES, POH remains
analog.
1 in, 4 out, 1 POH
Use AES in 4-channel
mode or LW to access all
the outputs.
With AES in 4-channel,
POH remains analog.
1 in, 1 out, 1 POH
Use analog, AES, or LW.
For AES, POH may be
analog or AES.
Show Mode
Two-show
Per show: 2 in, 2 out, 1
POH
Use AES in 4-channel
mode or LW to access all
the outputs.
For AES, POH remains
analog.
Per Show: 1 in, 2 out, 1
POH
Use AES in 4-channel
mode or LW to access all
the outputs.
For AES, POH remains
analog.
Per show: 1 in, 1 out, 1
POH
Use analog, AES, or LW.
For AES, POH may be
analog or AES.
Livewire can always be used for any of the four caller and two POH inputs. When a Livewire
input is enabled, the corresponding analog/AES input is disabled. Livewire can provide inputs 3
and 4 when they are not otherwise available at the XLR connectors.
Four caller audio outputs via Livewire are always possible, regardless of mode, in parallel and at
the same time as the XLR audio outputs.
AES Mode
On the Web interface, the Setup Wizard can be used to set the AES mode.
If your Nx12 is equipped with the optional AES module, there are two AES input and two
output XLRs, which may be configured as follows:
2-channel (default)
♦
In this mode there are up to two caller inputs/outputs.
e two AES input XLRs can either take one audio input each using only the L chan-
nels, or a combined L/R AES signal may be connected to the first AES input XLR.
e Nx12 will automatically sense if there is a second AES connection to XLR input 2.
If present, the Nx12 will take the second audio input from this XLR. If not present, the
Nx12 will take the second audio input from the R channel of AES input 1.
If your mixing console combines two caller sends into one AES L/R, plug this into the
first AES input XLR and use the first AES output XLR for the caller audio. If your
console uses two separate AES connections, use both XLR inputs and outputs.
Program on Hold is via the analog inputs.