Filter
Top Products
1.
11
I11
I11
]1111
1
.
1
1
11
]11
]111
ilill
11II
1II1
i
l
l
1I
1
11
11I
11I
11I11
1
11
I11I1
Ilillll
111;111
I'"
22
Exchange of endless tape magazine
If vou should need different messages and do not wantto record them again on each occasion it is
recommended to have various cartridges available. Spare cartridges are available at vour dealer.
The cartridge is to be exchanged as foliows:
Remove tape from its guides (tape pressure spring @ and rubber pressure roller @ marked read)
loosen fastening screw @ of cartridge with the help of a coin and lift up cartridge trom its resting
post.
The new cartridge can now be inserted (the shaft at the bottom of the magazine must fit into the
opening provided on the platform of the T 104). Refasten the cartridge with screw @. The tape
path is marked in white on the platform of the machine. Start inserting the tape loop at the right
hand side. For this purpose the rubber pressure roller and the tape pressure spring are once again
to be released at the levers marked in red.
In case the tape loop should be too narrow, pull some more tape out o(the cartridge on the left
hand side. If, however, the loop should be too wide,do not attempt to replace it into the cartridge.
The tape tightens itself whilst running.
Unrequired f;:artridges please keep in their original packing cartons.
Service and maintenance
When observing a certain amount of attention which is self-evident for aprecision product like
the T 104, the set works trouble-free also during permanent use. You should occasionallv clean
heads, tape guides and rubber roller with a piece of cloth saturated in methvlspirit. In case the
rubber pressure roller @ is cleaned please make sure that a thin film of talcum powder is put on
the rubber roller. BV doing this vou avoid a sticking of the tape on the rubber. Your dealer will
only be too pleased to attend to these small requirements. Should it become necessarv to ex-
change a lamp or a fuse, please also contact your dealer.
----
1_-
----