Filter
Top Products
Settings
58
Dialog-Info Call Pickup
snom phones subscribe to the status information of SIP URL's mapped
as “Destination” on the programmable keys. By turning this setting on,
the user will be offered a pickup if a mapped destination gets a call and
is in the ringing state. The display will change in the idle state to show
the source and destination of that call and the user can pick it up by
pressing the ENTER key
. The pickup offer will be available as long
as the destination is ringing and disappear when the user of the phone
offering pickup presses CANCEL
, when the call is connected, when
the call is cancelled by the caller, or when a third party picks up the call.
Call Waiting Indication
You can enable or disable the CWI on the phone through this setting.
Dialtone during Hold
Turning this setting on will produce a dial tone when a call is being held
and the user is trying to dial a second number. A dial tone will not be
played when this setting is not turned on.
Disconnect on On-hook
Sometimes it is useful to disable the disconnection of a call when the
handset is placed on-hook, e.g., during conference calls or handsfree
mode, etc. This can be achieved by turning this setting off.
Keys
Here you can change the key behaviour on the phone to your wishes.
The web page may look like this:
Break Key
The “Break” key on the phone can be used either to disconnect the
connected call or as a “Transfer” hard key. You can make that choice
through this setting.
Transfer on On-hook
In case the transfer feature triggered by on-hook is confusing you, you
can switch it off here.