Filter
Top Products
Page 68 of 113
intelligent wireless platform
airHaul
2
Nexus PRO™ User Guide
Valid Key
Chooses which key in the key table is used for authentication: 1 – 4
This value must be match between the root device and the Client.
Key Table
Display / Set WEP keys
A maximum of four keys can be set.
Follow the steps below to configure the Data Encryption parameters:
1. Click the ‘Security’ link from the ‘Radio Main’ page of the desired radio.
2. Click the ‘Enable’ button on the WEP.
3. Choose the Authentication as ‘Open System’ or ‘Shared Key’ by clicking on the radio button.
4. Choose a WEP Key Size (64 Bits or 128 Bits) from the dropdown menu. WEP key length is
10 characters for 64 Bits and 26 characters for 128 Bits.
5. Choose a Valid Key from the dropdown menu.
6. Enter the WEP key in the Key Table entries.
7. Click the ’Apply Changes’ button to change the settings.
Note: The system will validate the key entries and provide error or warning notifications.
The user must enter the key indicated by the Valid Key selection.
Figure 2-53 WEP Only Configuration