SkyLink ML-001 Telephone Accessories User Manual


 
21
36
Note:
- The control panel cannot be armed if there are triggered sensors. Make sure
all sensors are in closed position, i.e. (close all doors, windows, no movement
should be detected etc).
- The control panel can be armed if there are sensors with low battery or failure
warning.
2. After pressing the “ARM” button, the “ARM” LED will flash and you will have 45
seconds to leave the premises, this is called the exit delay. You will hear
beeping during the exit delay interval. The beeping rate will change from slow
to fast, the faster the beep rate, the less time you have left to leave the premises
before the siren sounds.
3. When the exit delay expires, the control panel will announce “System Armed”,
beeping will stop and the ARM LED will be on steadily. This indicates the
system is now armed.
Note:
The control panel can also be armed remotely when nobody is home, with a touch
tone phone. Please refer to “Remote Operation by Telephone” on page 27.
Disarming the system
If a sensor is triggered while the control panel is armed, such as entering a house
with an armed control panel, an entry delay will be triggered. User is allowed to
disarm the control panel during the 30-second entry delay. If the control panel is
not disarmed within 30 seconds, siren will sound immediately and emergency
calls will be made. To disarm the control panel, follow the instructions below.
1. During the entry delay, the system will beep for 30 seconds, the ARM LED will
flash during this entry delay interval. The faster the beep, the less time you
have left to disarm the control panel before the siren sounds.
OPERATION
1.Entering the premises
will trigger the entry
delay.
2.Enter password within
30 seconds or press the
disarm button on the
keychain remote.
3. Once the system is
disarmed, the Arm
LED will be off.
Beep Beep
Entry delay 30 seconds
Arm LED off
System
Disarmed
Beep Beep
Arm LED flashes
ADVANCED PROGRAMMING
Erase Keychain / Keypad Remotes
1
2
3
[PROG]
[MPIN]
Enter
Programming
mode
Enter master
password to pro-
gramming mode
3 beeps for valid
password. 1 long beep
for invalid password.
[0]
Select erase
remote
programming
After [0] is entered, some
zone LEDs will flash or stay
off. The zone LEDs
represent whether that zone
is occupied by any remote.
** See Table B below.
Select remote
location you
would like to
erase
After you have selected the
remote location, you will hear 3
beeps and verbal confirmation
[Device X Empty Memory],
where X is the remote location
you have selected.
To erase
an occupied
remote, press
[6] to [0].
Select a remote
location [6], [7],
[8], [9] or [0].
Remote [6] is represented by zone LED 1
ZONE LED DESCRIPTION
Off Zone is not occupied by any remote
Flashes twice This zone is occupied by a remote. You may select this zone to
erase this remote.
Flashes once This zone is occupied by a control module (Optional).
THIS IS NOT A REMOTE CONTROL, THEREFORE, SHOULD NOT BE
ERASED. (Refer to page 43 Erase Control Module for more
information)
Flashes once, This zone is occupied by a remote AND a control module.
then twice You may select this zone to erase the remote.
** Table B: Zone LED status for erasing keychain/keypad remote(s).
* Please refer to erase control module on page 43.
Step Keys Function Description Note
ZONE LED
1 6
2 7
3 8
4 9
5 0
REMOTE LOCATION
Follow the instructions below to erase keychain or keypad remotes / receivers.
®
OR