Filter
Top Products
E48
ADDITIONAL INFORMATION
Resetting the Handset Without the Base
If your original base is not available for some reason, you can still reset the handset and use it with another base.
Press and hold
and # for at least five seconds.
Move the cursor to select BASE UNAVAILABLE and then press MENU/SELECT. WHICH BASE? appears.
Select the base which you want to de-register from, and then press MENU/SELECT. BASE UNAVAILABLE appears.
Move the cursor to select YES, and then press MENU/SELECT. You hear a confirmation tone, and the handset deletes
its own base information without contacting the base. If the handset was registered to only one base, it displays
HANDSET NOT REGISTERED-PLACE HANDSET ON BASE TO REGISTER. SEE YOUR OWNER'S MANUAL FOR HELP. If
the handset is still registered to another base, it searches for the other base and then returns to standby.
After de-registering the handset, place the handset to the base to register.
You must re-register the handset before you can use it.
Traveling Out of Range
During a call, if you move your handset too far from your base, noise may increase. If you pass the range limit of the base,
the handset will beep, display OUT OF RANGE, and then go to standby. The base will maintain the connection for thirty
seconds after the handset goes out of range. If you move the handset back within range of the base within thirty seconds,
press /FLASH or to pick up the call again.
Note:
If it is set to automatically select the available base, the handset will begin searching for another base thirty seconds after going out of range.
( see Selecting the Base on page E16 ).
•
1.
2.
3.
4.
5.
UC590EH.indd E48UC590EH.indd E48 8/19/2008 11:39:13 AM8/19/2008 11:39:13 AM