Filter
Top Products
OfficeServ Link Version 2.1 User Guide Link Settings
--------------------------------------------------------------------------------------------------------------------------------------------------------------------
Page 22 © SAMSUNG Electronics Co., Ltd
Communication Environment Setup for user connection in standby
As soon as connections have been successfully completed with the telephone system, the
Link starts a process in order to perform the service needed to receive requests from users.
In the LAN-based TCP/IP case this listening port is set to 6000 by default. Usually this will
not need to be changed, but port numbers 1024 or higher can be used if necessary.
Values of 0 ~ 1023 have been already built in the Link.
A port currently being used for another service by the computer cannot be specified. There is
a command for you to check which TCP/IP port numbers are currently used. Use the
command at the command prompt of Windows as follows:
c:\>Netstat -a -e -n -p TCP
Figure 3.5 Status View of Ports in Use
Note The setting of communication environment can be done only in the offline status between Link
and telephone system. Online state (Disabled) does not allow you to activate this function button.