Filter
Top Products
•If [1. Manual IP] is selected,the user must enter the IP address, subnet mask,
and gateway value for the customer network that the 5112L resides on.
•If[2.DHCP] is selected,the IP address,subnet mask,and gateway value will be
set to the default values automatically. (Choose this option only if a DHCP
server is available on the local network).
• [3.PPPoE](Point to Point Power over Ethernet):This option is selected in some
cases when connecting directly to ISP (Internet Service Provider) equipment
without going through a local LAN. If so, you must enter the username/pass-
word assigned to you by the ISP to authenticate your internet connection.
Setting IP Manually
If [1. Manual IP] is selected the Network Setup
sub menu will be displayed.
The user directly enters the IP address, subnet
mask,and gateway, address as follows:
• If the [1.IP] menu is selected,the LCD will display
the following message and the user can enter
the ITP’s address.
Check if there is any currently saved IP address of the phone on the LCD.If the IP
address has not been set, the LCD displays nothing. The user can enter the IP
address using [0]-[9] dial buttons and [
✱✱
] button can save that IP address by press-
ing the [Enter] button of navigation button assembly.
• If the [2. Subnet] menu is selected, the user can
enter a new Netmask IP address.
Check if there is any currently saved subnet mask address of the phone on the
LCD. If the subnet mask address has not been set, the display will show nothing.
Press any dial buttons from [0]-[9] and [
✱✱
] button to enter the subnet mask IP
address and then save that subnet mask IP address by pressing the [Enter] button
of navigation button assembly.
• If the [3.Gateway] menu is selected the user can
enter a new gateway address.
The user can check if there is any gateway IP address of the phone that is current-
ly saved on the LCD.If the gateway IP address has not been set,the LCD will show
nothing.Use any dial buttons from [0]-[9] and [
✱✱
] button to enter the gateway IP
address and save it by pressing the [Enter] button of navigation buttons.
NOTE: If DHCP mode is selected,the IP address,Netmask,and Gateway will not be
displayed on the LCD.
Network Setup
1.IP
2.Subnet
3.Gateway
IP Address
xxx.xxx.xxx.xxx
Subnet
xxx.xxx.xxx.xxx
Gateway
xxx.xxx.xxx.xxx
13
5112l_guide.qxp 5/9/2006 9:19 AM Page 19