Filter
Top Products
Load and Upgrade Set/Modify
The fourth item [4. Load & Upgrade Setup] sets or modifies the IP phone’s soft-
ware version.Use extreme caution when upgrading the keyset.
Select the [4. Load & Upgrade] item.The screen below is displayed.
• [1.TFTP Server Setup]: This option is used to enter the IP address of the TFTP
Server which hosts the ITP software.
• [2.Upgrade Start]: When you select this option, the software from the TFTP
server will be pushed to the ITP phone.
Registering and Authenticating the ITP to your System
The fifth item [5. System Server Setup] sets or modifies settings related to the
registering the ITP to the MCP. Select the [5.System Server Setup]. The screen
below will be displayed.
You can set/modify the IP address of the MCP at the [1. System Server] item.The
screen below is displayed when you enter the item.The server IP is the IP address
of the MCP.
You can confirm the current IP address of the authentication server at the LCD
panel.The address is left blank if it is not set.Use the dial buttons from [0]-[9],and
[✱] to set the IP address and press the [ENTER] button among the navigation but-
tons to save and exit.
Next select the [2.System ID] item and the screen below will be displayed.
1.TFTP Server Setup
2.Upgrade Start
14
1.System Server
2.System ID
3.System Password
Server IP Address
xxx.xxx.xxx.xxx
Phone ID
xxxx
5112l_guide.qxp 5/9/2006 9:19 AM Page 20