Filter
Top Products
44
Stop message playback 2
Erase message 0 (during message playback)
Skip message 3
Turn off/on answerer 4
Review voice menu options 7
MEMORY FULL
When answering system memory is full, the system answers after 10
rings, beeps and waits for you to enter the 3-digit security code. If you
don’t enter the security code within 8 seconds, the phone hangs up.
You should erase some messages so the answering system can record
new messages.
NOTE: The unit also answers after the 10th ring if it is turned off. To access
the answering system, enter your 3-digit security code after you hear the beep.
CHANGING THE BATTERY
CAUTION: To reduce the risk of fire or personal injury, use only the
battery 5-2522 that is compatible with this unit.
1. Make sure the telephone is OFF (not in
talk mode) before you replace battery.
2. Remove the battery compartment cover.
3. Disconnect the cord attached to the
battery pack from the jack inside the
battery compartment and remove the
battery pack from the handset.
4. Insert the new battery pack and reconnect
the battery plug.
5. Put the battery compartment cover back on.
6. Place handset in the base or handset charge cradle to charge. If you
don’t charge the handset battery properly (for 16 hours) when you first
set up the phone and/or when you install a new battery pack, the
battery ’s long-term performance will be compromised.
Battery
compartment jack
Battery pack
Battery
compartment
Battery pack
plug