Filter
Top Products
The Integrated Answering Device
35
Choosing between the two outgoing
messages
Press
OGM. Then press OGM again when the
outgoing message is played. This switches
between the prerecorded greeting or the personal
greeting. After finishing playing back the message,
a confirmation tone is heard.
Setting the base ringer volume
You have three ringer options. One allows you to
turn the ringer off. The other two are volume
levels.Ô
1. Press
SET/RING.
You hear the ringer at the current volume level
([ ] High, [ ] Low, [ ] off) (if you set the base
ringer volume to off, “Ringer off” is announced)
and it is displayed on the base.
2. Press
SET/RING until the desired ringer option
appears.
3. The system displayed new ringer volume.
Temporarily Mute the Base Ringer
Press
PLAY/STOP to temporarily mute the
incoming ring. The ringer will sound with the next
incoming call.
Adjusting the speaker volume level
You can adjust the volume of the base speaker by
pressing the
VOL/SEL/ or VOL/SEL/ on the
base. Press
VOL/SEL/ for louder or VOL/SEL/
for softer during the base speaker is being used
except for menu mode. Ô
The numbers - are displayed on the base
indicating the volume levels. being the softest
and being the loudest.
Ô NOTE Ô
• When you have set the
base ringer to off and the
handset is on the base,
you will still hear the
ringer from the handset.
• When you press VOL/
SEL/
at 9 or VOL/SEL/
at 0, an error tone
sounds.
43-3824.FM Page 35 Friday, February 28, 2003 6:50 PM