Filter
Top Products
The Integrated Answering Device
31
announced for your review. After a few seconds,
the system announces “To set security code, press
menu again”.
Setting a Personal Security Code (PIN)
To play your messages from a remote location, you
need to enter a two-digit Personal Identification
Number (PIN) code (01-99). To select a PIN,
perform the following steps: Ô
1. Press
MENU twice in standby mode.
“Security code” and the current PIN code is
announced as it is displayed on the base.
Then the system announces the guidance for
setting the PIN code.
2. Press
VOL/SEL/ or VOL/SEL/ until the
desired number appears.
3. Press
SET/RING to select the PIN code. You
hear a confirmation tone, then the
announcement “Security code” and the new
PIN code is announced. After a few seconds,
the system announces “To set ring time, press
menu again”.
Setting the ring time
The ring time setting allows you to set the number
of rings the caller hears before your answering
system plays the outgoing message. You can set
the ring time to answer after two, four, or six rings.
Setting (Toll Saver), the answering system picks
up after two rings if you have new messages, and
after four rings if there are none. This way, if you
make a long distance call to check your messages,
you can hang up after the second ring to avoid
billing charges.
1. Press
MENU three times in standby mode.
Ô NOTE Ô
The PIN code is set to “80”
when you purchase your
phone.
43-3824.FM Page 31 Friday, February 28, 2003 6:50 PM