Filter
Top Products
Operation
15
ADJUSTING THE HANDSET RINGER
AND EARPIECE VOLUME
Handset Ringer Tone and Volume
Press VOL/ or VOL/ in standby mode to select
one of five ringer tones and volume combinations.
Earpiece Volume
Pressing VOL/ or VOL/ during a call will change
the earpiece volume of the handset. This setting will
remain in effect after the telephone call has
ended.Ô
Temporarily Mute Ringer
If the handset is off the base, simply press end to
temporarily mute the incoming ring. The ringer will
sound with the next incoming call.
REDIAL
The REDIAL/PAUSE key redials the last number
dialed. The redialed number can be up to 32 digits
long.
TONE DIALING SWITCH-OVER
Some telephone companies use equipment that
requires pulse dialing (sometimes referred to as
rotary dialing). If you need to enter tone dialing
digits, you can switch-over to tone dialing during the
call. For example, entering your bank account
number after you have called your bank. Ô
Initially make your call with the pulse dialing
mode.Ô Once your call connects, press
∗/TONE/.
Enter the desired number. These digits will be sent
as tone dialing. Once the call ends, the tone mode
is canceled and pulse dialing mode resumes.
TRAVELING OUT-OF-RANGE
During a call, as you begin to move your handset
too far from your base unit, noise increases. If you
Ô NOTE Ô
Earpiece Volume
When you press VOL/ in
Maximum mode or VOL/
in Low mode, an error tone
sounds.
Tone Dialing Switch-over
• The tone feature only
applies when the dial
mode is set to pulse.
• This special number can
be stored in a memory
location. This is referred
to as Chain Dialing (See
page 20.)
43-3824.FM Page 15 Friday, February 28, 2003 6:50 PM