Filter
Top Products
Getting Started with Your Phone
1 - 7
Before You Use Your Phone
Phone Location
Place your phone in a well-ventilated, flat, level, clean, and dry location near
your computer.
Connecting to Microsoft Lync 2010
After you have plugged the USB (connected to your phone) into your
computer, the CX300 splash screen appears.
If the Microsoft Lync 2010 is not running on your computer or the correct
version is running, but you are not signed in, the Sign In screen appears.
If theMicrosoft Lync 2010 that is running on your computer is an older version,
the Upgrade Screen appears. Contact your system administrator.
Configuring Microsoft Lync 2010 for the Polycom CX300 Desktop Phone
Before using your phone, you must verify that the Microsoft Lync 2010 audio
settings are properly configured to route incoming and outgoing audio to and
from your phone.
To verify or configure Microsoft Lync 2010:
1 Start the Microsoft Lync 2010 application.
2 In the Microsoft Lync 2010 title bar, click the down arrow near the upper
left corner.
3 Select Tools, click Set up Audio and Video..., and then follow the
instructions in the Audio and Video Device Setup wizard.