Philips S10A Cordless Telephone User Manual


 
English
EN 7
Install the handset
Your handset comes with a high quality Lithium
Ion Polymer battery to maximize battery
lifetime. However, over time the capacity of the
battery will decrease. You can order replacement
batteries through the Philips website or Philips
service.
Caution
Risk of explosion! Keep batteries away from heat,
sunshine or re. Never discard batteries in re.
Use only the supplied battery.
Note
Charge the battery for 6.5 hours before rst use.
Warning
Check the battery polarity when inserting in the
battery compartment. Incorrect polarity may damage
the product.
Check your phone’s software
version
Before setting up your phone, make sure you
have the latest software available for your phone.
1
Install the [Philips Phone Manager]available
for free at www.philips.com/support (see
chapter 8).
2
Connect the phone through a micro USB
cable (available at most electronics stores
or through Philips service network).
3
If a new software is available, the [Philips
Phone Manager] will display a message.
You can also check the current software version
in
> [Firmware version] and compare it
with the software version displayed at www.
philips.com/support.
Congure your phone
(country dependent)
Turn your phone on/off
Press until you see the Philips wordmark.
Set the country/language
Select your country/language, then tap [Apply]to
conrm.
» The country/language setting is saved.
Note
The country/language setting option is country
dependent. If no welcome message is displayed, it
means the country/language setting is preset for your
country. Then you can set the date and time.
To re-set the language, see the chapter ‘Settings’,
section ‘Phone settings’.
Set the date and time
Set your date, date format, time and time format,
then tap [Apply]to conrm.
Advanced settings
You can tap [Advanced setup] to set the [Eco
mode], [ECO+ mode] or [Silent mode]. For
information, refer to the chapter on [Phone
settings].
Tip
To set the menu under [Advanced setup] later, press
[OK] to skip this setting.