Filter
Top Products
4
Important Safety Instructions
IF YOUR PRODUCT UTILIZES BATTERIES,THE
FOLLOWING ADDITIONAL PRECAUTIONS
SHOULD BE OBSERVED :
1
Use only the type and size of battery(ies)
specified in the user manual.
2
Do not dispose of the battery(ies) in fire.
They may explode. Check with local codes for
possible special disposal instructions.
3
Do not open or mutilate the battery(ies).
Released electrolyte is corrosive and may
cause damage to the eyes or skin. It may be
toxic if swallowed.
4
Exercise care in handling battery(ies) in order
not to short out the battery(ies) with
conducting materials such as rings, bracelets,
and keys.The battery(ies) or conductor may
overheat and cause burns.
5
Do not attempt to recharge the battery(ies)
provided with or identified for use with this
product that are not intended to be
charged.The battery(ies) may leak corrosive
electrolyte or explode.
6
Do not attempt to rejuvenate the battery(ies)
provided with or identified for use with this
product by heating them. Sudden release of
the battery(ies) electrolyte may occur causing
burns or irritation to eyes or skin.
7
When replacing battery(ies), all batteries
should be replaced at the same time. Mixing
fresh and discharged batteries could increase
internal cell pressure and rupture the
discharged battery(ies). (Applies to products
employing more than one separately
replaceable primary battery.)
8
When inserting battery(ies) into this product,
the proper polarity or direction must be
observed. Reverse insertion of battery(ies)
can cause charging, and that may result in
leakage or explosion.
9
Remove battery(ies) from this product if
storing over 30 days because the battery(ies)
could leak and damage the product.
10
Discard “dead” battery(ies) as soon as
possible since “dead” batteries are more likely
to leak in a product.
11
Do not store this product, or the battery(ies)
provided with or identified for use with this
product, in high temperature areas. Batteries
that are stored in a freezer or refrigerator for
the purpose of extending shelf life should be
protected from condensation during storage
and defrosting. Batteries should be stabilized
at room temperature prior to use after cold
storage.
12
If your product uses rechargeable
battery(ies), charge the battery(ies) only in
accordance with the instructions and
limitation specified in the User Manual.
SAVE THESE INSTRUCTIONS
1.1 Safety information
This telephone is not designed for making
emergency telephone calls when the power fails.
An alternative should be made available for access
to emergency calling.
1.2 Power requirements
This product requires an electrical supply of 120
volts, single phase alternating current, excluding
IT installations defined in standard UL 60950.
1.3 Battery requirements
The handset requires power source of two
rechargeable NiMH batteries, size AAA 1.2V
750mAh (Hr11/45). IF THE INCORRECT TYPE
OF BATTERIES ARE USED, A WARNING
MESSAGE WILL BE DISPLAYED.
Use only Philips Multi-Life 750mAh rechargeable
NimH batteries.
For servicing or replacement, you can purchase a
suitable headset through service center or retail
shop.
Warning
The electrical network is classified as dangerous
according to criteria in the standard UL 60950.
The only way to power down this product is by
unplugging the power supply from the electrical
outlet. Ensure the electrical outlet is located
close to the apparatus and is always easily
accessible.
1.4 Telephone connection
The voltage on the network is classified as TNV-
3 (Telecommunication Network Voltages, as
defined in the standard UL 60950). Following a
power cut, the call in progress is lost.
!
CD645_IFU_US_English.book Page 4 Friday, August 3, 2007 5:10 PM