Filter
Top Products
38
Frequently asked questions
Caller does not hear me!
• Microphone may be muted: During a call, press
> to unmuted the microphone.
Noise interference on your radio or
television.
• Move the power adapter or base station as far
away as possible
Product behavior
Caller Line Identification (CLI) service
does not work.
• Check your subscription with your network
operator
A phonebook entry cannot be stored.
• Check if the phonebook memory is full, delete
an entry to free memory.
The handset is unable to register.
• Make sure that
p has been pressed for 3
seconds
• Each base can only register up to four handsets
Answering Machine
The answering machine does not record
calls.
• Make sure the answering machine is
connected to the power adaptor, and the
power adaptor is plugged into mains supply
which is switched on.
• Check if the answer machine is off, or Answer
only mode is selected.
• Check to see if the answering machine is
memory full. If so, delete some or all messages.
• Try switching off the power at the main socket,
and then turn it on again after 1 minute.
Unable to perform remote operation.
• Make sure the remote access is on (see Section
6.6.4.2)
• Make sure you entered the correct remote
access code
• Use a touch-tone phone
Note
If the above solutions do not help, remove the
power from both the handset and the base. Wait
for 1 minute and try again.
CD645_IFU_US_English.book Page 38 Friday, August 3, 2007 5:10 PM