Filter
Top Products
S-ICX-50-200 S-ICX (International) issued October 2000 19
This card can be installed in any flexible slot.
Digital Extension Card - DEC/16, DEC/24 (VB-44612UK, VB-44613UK)
These two cards provide 16 and 24 circuits, respectively, and can only be used with the CPC-M. Each
circuit supports the Panasonic Digital Key Telephone, Digital Single Line Telephone, DSS/72, and EM/
24. Supply voltage for the telephone is supplied by the digital circuits.
This card can be installed in any flexible slot.
Analog Extension Card - SAEC/4 and SAEC/8 (VB-44621UK, VB-44622UK)
This card provides 4 and 8 analog circuits, respectively. Each circuit supports standard analog
telephone devices such as analog telephones, answering machines, fax machines, modems,
cordless telephones, etc. The connected device(s) can be either pulse dial (rotary) or DTMF. Ringer
circuitry is built into the card. This card can only be used in Special Slot 2. DO NOT insert card while
unit is powered on.
Analog Extension Card - AEC/8 (VB-44620UK)
This card provides 8 analog circuits. Each circuit supports standard analog telephone devices such as
analog telephones, answering machines, fax machines, modems, cordless telephones, etc. The
connected device(s) can be either pulse dial (rotary) or DTMF. Ringer circuitry is built into the card.
This card can be installed in any flexible slot.
Analog Proprietary Extension Card (APEC/8) (VB-44660UK) UK only
The APEC/8 card is an interface card for SBS or VB-9 / A-series proprietary key telephones. A
maximum of eight (8) extensions can be connected to each APEC/8 card.
The APEC/8 card is mounted in a flexible slot. This card accommodates 8-extensions. The
connection is 4-wires to each extension.
ISDN Primary Rate Interface Card (T/S-point) - PRI/30 (VB-44540UK)
The PRI/30 card supports both S-point and T-point ISDN. See pg. 18 for more information.
ISDN Basic Rate Interface Card (S-point) - SBRI/4 (VB-44630)
This unit supports Basic Rate Interface (2B+D:144kbps) for S-point ISDN. Each card provides 4 BRI
circuits.
This card can be installed in any flexible slot.
The S-point BRI Unit supports information transferring capability (speech and data) at the Exchange.
ISDN Interface Card (S-Point/T-Point) - STBRI/4 (VB-44531) UK only
This ISDN Basic Interface (2 B+D: 144 kbps) card is mounted in a flexible slot, and can be switched to
either S-point or T-point use by the port base.
When more than one circuit is used for T-point, the card is connected through a Network Termination
Unit (NT1) to the ISDN trunk, which supports the T-point ISDN basic interface.
The card has an on-board, 4-circuit T-point ISDN basic interface and lightning arrester built-in. It also
provides a network clock synchronizing function.